Injection molding machine how to solve these failures, you know it


Release time:

2024-06-24

Life we can often see the plastic products, large to automotive products, small to toothbrush toothpaste, smart bracelet, we can not get away from it, daily life with plastic products are almost all produced by it, you have not seen it, but you must have indirectly used it to produce items, it is the injection molding machine.

Injection molding machine how to solve these failures, you know it

Life we can often see the plastic products, large to automotive products, small to toothbrush toothpaste, smart bracelet, we can not get away from it, daily life with plastic products are almost all produced by it, you have not seen it, but you must have indirectly used it to produce items, it is the injection molding machine.

Injection molding machine is a use of molds to make plastic into a variety of plastic products of large-scale equipment, because of its working principle and injection syringe similar, so it is also known as the injection molding machine, nowadays, with the upgrading of the industry changes, many industries on the demand for plastic products has increased greatly, need to use the injection molding machine. Injection molding machine operation process is cumbersome, even if the understanding of the personnel are inevitably some problems, resulting in the injection molding machine can not function properly.

Before starting the machine, the staff should carefully check whether there is any foreign matter in the power supply and interface of the injection molding machine. If there is a problem during the use, you can't operate in a chaotic manner, and you should carefully and meticulously analyze where the equipment failure occurs. The following are some of the more common problems and solutions in the use of injection molding machines:

First, after starting the power supply machine does not run, you should carefully check the interface, whether there is a burnt taste and other odors, check whether it is poor contact, or line overload, causing tripping, confirm the cause of the failure in time to overhaul or replace the relevant parts.

Second, the oil pump abnormal sound, may be the oil pump air intake, oil level is too low, or filter blockage, should overhaul the joints, add enough oil or clean the filter.

Third, the injection speed is slow or not injected, the reason may be the pressure is low, the injection speed is slow, the correct solution is to raise the injection pressure.

Injection molding machine in the use of the process of problems is normal, the machine used will have wear and tear, in the use of the time, often check the maintenance, can effectively protect the machine, extend the service life of the machine and equipment.